A new gas range, a fireplace insert, or a grill on the patio can all mean running a new gas line. It is common work, but it is also work where small mistakes matter. Here is what goes into adding a gas line, what to plan for, and why an unused line should never just be left open.
What goes into adding a gas line
A new gas line is a branch off your existing gas piping, run to the spot where the new appliance will sit. A good plan covers a few key questions:
- Where the line will tie in. The new branch connects to existing piping, usually somewhere in the basement, crawlspace, or garage.
- How big the pipe needs to be. Gas pipe is sized based on how much gas the appliances use and how far the gas has to travel. Your existing system also has to carry enough gas for everything running at once.
- What material to use. Black steel pipe and flexible corrugated stainless steel tubing, often called CSST, are both common. CSST has its own bonding requirements under the fuel gas code.
- How the appliance connects. The last few feet often use a listed flexible appliance connector.
Shutoff valves and sediment traps
The residential fuel gas code calls for each appliance to have its own shutoff valve, generally in the same room and within 6 feet of the appliance, where it can be reached. Many appliances also need a sediment trap near the inlet, a short capped pipe that catches debris before it reaches the gas controls. Some appliances, like ranges and dryers, are not always required to have one, so this depends on the code your city uses and the appliance instructions.
Planning for a range
A gas range usually needs a gas outlet behind it and an electrical outlet for the igniters and controls. Plan for the range to slide back without crushing the connector. A new range is a good time to replace an old flexible connector rather than reuse it.
Planning for a fireplace or insert
Gas fireplaces and inserts have their own venting and clearance rules. The manufacturer's instructions spell out where the gas connection and shutoff valve can go. Venting is a separate part of the job and needs the same attention as the gas line.
Planning for an outdoor grill
An outdoor line often means running pipe through a wall and sometimes under the yard. If any digging is involved, Washington law requires calling 811 before you dig so buried utilities can be marked. In our wet climate, outdoor fittings and valves should also be rated for outdoor use and protected from damage.
Permits and inspection
Adding or extending gas piping almost always needs a permit and inspection, and rules vary by city. Inspections usually include a pressure test to make sure the new piping holds tight before it is put into service. Washington homeowners can do some work on their own home with a permit, but gas work carries real risk, so check with your city or Washington L&I before you start.
Capping unused lines
When a gas appliance is removed, the line that fed it should be properly capped or removed, not left with an open valve or loose fitting. Over time, an unused stub can get bumped, opened by mistake, or forgotten. If you have an old gas line where a range, dryer, or fireplace used to be, it is worth having it checked. See a recent example in our Mercer Island gas line cap job.
When to call a professional
Call a qualified gas technician if you are adding a gas appliance, moving one, or running a line outdoors. Also call if you have an unused gas line that is not capped, a shutoff valve that is stuck or hard to reach, or an old flexible connector you are not sure about.
OutToday serves Bellevue and the Eastside. If you are planning a new range, fireplace, or grill, call us at (425) 615-5000 and we will help you plan a gas line that is sized right, permitted, and safe.
Want a professional opinion?
Call us any time, day or night, at (425) 615-5000, or book online. Written pricing before any work begins.
Related services:
