Add-a-wire kit for a Daikin system thermostat.
The existing cable was one conductor short, so we fitted an add-a-wire kit instead of fishing new wire through the wall.
From our job records · May 2026
Same-day furnace repair across the Eastside — we diagnose the real problem first, then hand you a written price before any work begins.
Furnace calls in Renton run the gamut -- lakefront and view-lot systems in Kennydale and the Highlands, and older mid-century furnaces on the bluff in Talbot Hill or down in Cascade. We diagnose the actual cause before recommending anything.
Furnace repairs in the Seattle area typically cost $139 to $544, with an average of $341, according to Angi's Seattle cost data (a 2026 regional estimate, not our pricing). Flame sensors and ignitors are at the low end; blower motors and control boards are at the high end.
| Seattle-area furnace repair (Angi, 2026) | Range |
|---|---|
| Typical repair | $139 to $544 (average $341) |
| Flame sensor | $160 to $270 |
| Ignitor | $160 to $540 |
| Control board | $220 to $650 |
| Blower motor | $160 to $2,160 |
| OutToday item | Price |
|---|---|
| Service call (diagnostic included) | $149 |
| Flame sensor replacement | $190 to $589 |
| Ignitor replacement | $385 to $540 |
| Thermostat replacement | $310 to $2,750 |
| Furnace tune-up | $149 |
Repairs are quoted in writing after the diagnosis, and you approve the price before any work begins. Updated October 2026.
We size every system to your actual demand — not a one-size guess. Here's what a typical furnace repair includes:
| Service | Furnace Repair |
|---|---|
| Category | HVAC / Heating |
| Dispatch | Same-day |
| Service call | $149, diagnostic included |
| Warranty | Workmanship guaranteed |
The existing cable was one conductor short, so we fitted an add-a-wire kit instead of fishing new wire through the wall.
From our job records · May 2026
Wired the new thermostat to the furnace, checked for a C-wire and confirmed heating and fan calls.
From our job records · May 2026
Installed a new control board and verified the full ignition and blower sequence.
From our job records · Jan 2026
Cleaned and tested the furnace and documented its condition so the homeowner knew what to expect from the season.
From our job records · Apr 2025
The gas valve meters fuel to the burners, and when it fails the furnace will not light. Installed a factory-rated replacement and ran the ignition sequence to confirm normal operation.
From our job records · Dec 2024
The $149 service call with the diagnostic included. Findings and a written price before any repair.
From our job records · Jan 2022
Pulled from our own job log. No customer names, addresses, or contact info shown, by design.
“Rodney was great. He fixed the problem with my furnace/Nest thermostat. Gave me a very honest assessment about the situation. Did not try to oversell anything.”
“My furnace stopped working during a cold snap, and OutToday Heating & Air came out within 24 hours to fix it. The technician was friendly, professional, and got everything working quickly.”
“Our furnace quit working at 11 o’clock at night and they were there at seven in the morning and the job was completed by 9:30. Could not be happier. House is warm again.”
Excerpts from public Google reviews, shown with first name and last initial. 273 Google reviews, 4.7 average. Read all reviews on Google.
Most furnaces we see in Renton are worth repairing. Ignitors, flame sensors, pressure switches, capacitors and even blower motors are normal wear parts, and replacing one usually buys years of service.
We will tell you plainly when replacement makes more sense: a cracked heat exchanger, a furnace past about 20 years old that needs a major part, or repeated repairs in a single season. In those cases we give you written options for a new furnace, a heat pump or a dual-fuel system, and check which utility rebates your address qualifies for.
No heat tonight? See emergency heating repair in Renton. Ready to replace? See furnace installation in Renton, or browse everything we do in Renton.
Mid-century homes in Cascade and the Highlands often have older gas furnaces and undersized ducts, and lakefront Kennydale homes deal with more humidity. Many Renton furnaces we repair are 20 years old or more, and some are on original duct systems that make them work harder. On these units the usual failures are worn ignitors, dirty flame sensors, tired blower motors and cracked draft inducers. We check the heat exchanger on every older unit before we recommend a repair.
Most furnace repairs do not need a permit; gas line work or a furnace replacement usually does. Mechanical and plumbing permits in Renton go through the City of Renton Development Services. When the work needs a permit, we pull it, schedule the inspection and leave you the paperwork.
Renton homes get electricity from PSE, and most have PSE natural gas. Renton homeowners may qualify for utility, state or federal rebates. We point you to the current programs for your address before you sign.
Our job records show more than 60 completed jobs for Renton customers across ZIP codes 98059, 98058, 98056, 98055, 98057. We take furnace repair calls in Renton Highlands, Kennydale, Talbot Hill, Benson Hill, Cascade and the rest of Renton.
Upfront written pricing, clean job sites, and a workmanship warranty backed by OutToday.
Book this serviceEvery furnace repair job in Renton starts with a diagnosis and an upfront written price you approve before any work begins.
Call (425) 615-5000Mechanical and plumbing permits in Renton go through the City of Renton Development Services. For furnace repair, we apply for the permit, book the inspection, meet the inspector on site, and give you the final sign-off for your records.
We repair natural gas, propane and electric furnaces in Renton. The $149 service call includes the diagnostic, and you approve a written price before any repair starts.
Our job records show more than 60 completed jobs for Renton customers across ZIP codes 98059, 98058, 98056, 98055, 98057. We take furnace repair calls in Renton Highlands, Kennydale, Talbot Hill, Benson Hill, Cascade and the rest of Renton. Call (425) 615-5000 for same-day service.
An OutToday furnace repair visit in Renton starts with a $149 service call that includes the diagnostic. The total depends on what failed, and you approve a written price before any work begins. Common repairs like an ignitor, flame sensor or pressure switch are usually finished the same visit.
We dispatch same-day across Renton for most furnace repair calls, 24 hours a day, seven days a week. Call (425) 615-5000 or schedule online.
Yes. OutToday is a WA L&I registered contractor (#OUTTOL*832B4) and every technician is background-checked and insured.
Yes. Every job is backed by the OutToday workmanship warranty described above, and you approve a written price before any work begins.
Zoned, ductless comfort for additions, ADUs, and rooms that never quite reach the right temperature.
Learn moreOne electric system that heats and cools — the cold-climate models we install work down to -13°F — and pairs with solar.
Learn moreHeat pump not heating, cooling, or defrosting right? Same-day diagnosis with a written price before any work begins.
Learn moreA properly sized, high-efficiency furnace for Pacific Northwest winters.
Learn more